Project

General

Profile

Actions

Bug #34

closed

Problem booting with Core 9

Added by ndary over 7 years ago. Updated over 7 years ago.

Status:
Closed
Priority:
Normal
Assignee:
Start date:
06/03/2017
Due date:
% Done:

0%

Estimated time:

Description

upgraded successfully to core 9

but when powering on the board, the ExclairXL boot one out of six times..
when it does not boot i get a message on the screen "image out of range" on my VGA screen and no Signal on HDMI

Switched back to CORE8 and could power OFF/ON the EclairXL to boot every time

Nir


Related issues 3 (0 open3 closed)

Related to Bug #17: NTSC crashing on some buildsClosed05/12/2017

Actions
Related to Feature #2: PBI supportClosedfoft04/04/2017

Actions
Related to Bug #39: Internal turbo freezer crashes on v9Closed06/03/2017

Actions
Actions #1

Updated by foft over 7 years ago

  • Related to Bug #17: NTSC crashing on some builds added
Actions #2

Updated by foft over 7 years ago

Its either board-board instability due to small timing differences or the new input pins I guess.

Can you check the voltage on these pins on PBI? They should all be 5V, I'm wondering if some are not pulled up. I guess I need to double check I put the correct pin for them in the .qsf file too!
PBI_EXTSEL_N : IN STD_LOGIC;
PBI_MPD_N : IN STD_LOGIC;
PBI_REF_N : IN STD_LOGIC;
PBI_IRQ_N : IN STD_LOGIC;

https://en.wikipedia.org/wiki/Parallel_Bus_Interface

Actions #3

Updated by foft over 7 years ago

Though thinking some more if you get 'no sync' then that is before all the new logic starts, so more likely the build-build instability on some boards only.

Actions #4

Updated by foft over 7 years ago

Actions #5

Updated by foft over 7 years ago

  • Related to Bug #39: Internal turbo freezer crashes on v9 added
Actions #6

Updated by foft over 7 years ago

One thing to try, can you see if it's the same with a few different power supplies?

Actions #7

Updated by ndary over 7 years ago

i did with same result, can anyone else confirm that core 9 works on on his v2 board?

Nir

Actions #8

Updated by foft over 7 years ago

Thanks for checking Nir. I guess it must be on the 'edge' and thus some boards work and not others. Its working well here, until I run Numen or try to use the internal freezer. They are real logic bugs though rather than a stability thing.

Actions #9

Updated by Stephen over 7 years ago

ndary wrote:

i did with same result, can anyone else confirm that core 9 works on on his v2 board?

Nir

Just wanted to say that so far core9 has been working fine for me.

Actions #10

Updated by ndary over 7 years ago

  • Status changed from New to Closed

this happen on every core after flashing, to solve it i simply remove and put back the SD Card and it works

Actions

Also available in: Atom PDF