EclaireXL

h1. EclaireXL Enclosures

The original EclaireXL was designed to fit in a Mini-ITX form factor case. These can be purchased from any store that sells computer components and cases.

The EclaireXL in mini form has several 3-d printed cases for it.

The first cases were created by and are here:

http://www.64kib.com/atarixlfpga_svn/trunk/atari_800xl/eclaireXL_ITX/hardware/case/mini/stl/case_common_top_v2.stl

http://www.64kib.com/atarixlfpga_svn/trunk/atari_800xl/eclaireXL_ITX/hardware/case/mini/stl/case_common_bottom_v2.stl

http://www.64kib.com/atarixlfpga_svn/trunk/atari_800xl/eclaireXL_ITX/hardware/case/mini/stl/Cartridge%20v8%20top_up.stl

WT808 from the Atari Age Forums created some as well. These are located on the Thingiverse site.

The case for the original run of the EclaireXL in mini form are here:

https://www.thingiverse.com/thing:3562690

The case for the Summer 2019 run with the cartridge port holes moved back slightly and a cut out for the SD card slot are here:

https://www.thingiverse.com/thing:3779401

If you do not have a 3-D printer, there are web sites where you can upload the file and have a part printed for you.

Also, some libraires have 3-D printers that you can use to print parts.

Finally, you could also consider asking in the Atari Age forums to see if anyone there would be willing to print one for you.

Or, maybe consider buying your own 3-D printer. There are some fairly decent ones for less than $200.