EclaireXL

h1. Introduction

For now please see the general core manual on the main page.

http://www.64kib.com/

h1. Power requirements

USB B 5V input. 500mA is enough but I'd go with 1-2A to give some extra for any connected devices.

h1. Core location

h2. v1 prototype (initial run on 5)

http://www.64kib.com/autobuild/private/prototype_v1/

(changes: http://www.64kib.com/autobuild/private/prototype_v1/changes)

h2. v3 (aka v2!) prototype (run on 10 and subsequent run of 20, with fixes)

http://www.64kib.com/autobuild/private/prototype_v2/

(changes: http://www.64kib.com/autobuild/private/prototype_v2/changes)

h2. v3.1 (aka v3!) prototype (only Panos has one)

http://www.64kib.com/autobuild/private/prototype_v3/

See the file changes for what I've changed.

h1. Board setup videos

I put together some basic videos for the v2 boards:

https://www.youtube.com/playlist?list=PLYGeDt6lv-p5R4DwdcHtmYUbfL6lOcYLb

h1. SD card setup

The OS and basic rom are loaded from the flash chip in the new cores, this can still be overridden by the sd card as discussed here:

http://www.64kib.com/redmine/boards/1/topics/22?r=26#message-26

h1. Flashing

[[Flashing using the USB blaster]]

[[Flashing using the SD card]]

[[Converting flashing files]]

h1. Svideo/composite on v2

On the v2 board svideo and composite are output via the vga connector:

For svideo luma is on the green output and chroma on the blue output.

For composite luma is on the green output. 

h1. Board information

[[Pinouts]]

[[V2Issues]]

h1. Keyboard mapping

The keyboard is mapped to match the standard Atari keyboard layout. It assumes you are using either an ISO or ANSI keyboard. I highly recommend buying stickers from here: https://www.4keyboard.com/commodore/591-2840-commodore-atari-non-transparent-keyboard-stickers.html

For an ISO keyboard:

!http://www.64kib.com/autobuild/keyboard.JPG!