Actions
Support #29
closedLED for SIO activity
Status:
Closed
Priority:
Low
Assignee:
-
Start date:
06/01/2017
Due date:
% Done:
0%
Estimated time:
Description
Where can I connect a LED to indicate SIO activity (soldering is not a problem, if required)?
POWER and RESET are connected, but there is a HDD LED, which would be good to connect to somewhere :)
Updated by foft over 7 years ago
Interface 2 pin 36 (SIO out) and interface 2 pin 31 (GND). With a suitable resistor of course since this is 5V.
Updated by jozsef over 7 years ago
Connected to SIO-IN and 5V (SIO-IN is reversed). Works fine. Thank you.
Updated by foft over 7 years ago
- Status changed from New to Closed
Great, closing. I'll note on the wiki that we should have a header for this on the final board.
Actions