Project

General

Profile

Activity

From 08/19/2015 to 09/17/2015

09/17/2015

11:44 PM Revision 409 (repo2): Moved traces away from mounting holes to remove risk of taking out traces with screws... Harder than expected!
markw

09/13/2015

10:07 PM Revision 408 (repo2): Fixed audio connector footprint/location. Fixed oscilator footprint (fitted but was too large). Added 16 pin support for serial init rom. Moved reset switch location to allow this. Added pull ups and decoupling to ADC (still untested). Added some more 2.5mm drill holes on the right for stencil positioning. Increased 2.5mm drill size by 1 notch (was too small to fit). Added solder pads for din connectors. Fixed footprint for phono connector. Increased resistor array size to allow fixing by hand more easily. Added pin headers to allow bypassing resistor arrays in case of issues soldering thsm! Added pin header borders to board to make it clear how much space is needed around them for sockets. Made room for jtag pin header socket. Increased version to v1.1. Added decoupling cap to oscillator. Added voltage test point header. Power ADC by 5V (it allows 2.7V to 5.5v but higher reduces changes of breaking it by high voltage inputs I think). Think thats it. Will review a bit then make the next board revision.
markw

08/20/2015

09:40 PM Revision 407 (repo2): Way to scanning for bad connections on gpio ports and store in ram
markw
09:40 PM Revision 406 (repo2): Way to scanning for bad connections on gpio ports and store in ram
markw
09:39 PM Revision 405 (repo2): ip for loading into passive serial chip - not included for now
markw
09:38 PM Revision 404 (repo2): ip for loading into passive serial chip - not included for now
markw
07:21 AM Revision 403 (repo2): add vga clock. Revert keyboard response change, it was correct before there are just gpio shorts/bad conns
markw
07:19 AM Revision 402 (repo2): Set chip type for builds with internal rom and ram
markw
07:18 AM Revision 401 (repo2): run quartus!
markw
07:17 AM Revision 400 (repo2): debugged
markw
07:17 AM Revision 399 (repo2): Add low drive strength, particularly while checking for shorts!
markw

08/19/2015

09:51 PM Revision 398 (repo2): fix keyboard. Add a hardware test gpio version to just turn on each pin in turn.
markw
 

Also available in: Atom