Project

General

Profile

Actions

Flashing using the USB blaster » History » Revision 3

« Previous | Revision 3/5 (diff) | Next »
foft, 05/27/2018 07:15 PM


Flashing using the USB blaster

Its possible to update the core using the USB blaster
To do this:
#Connect power to the board
#Connect the jtag
#In quartus go to tools->programmer
#In the programmer select 'add file' and choose the .sof or the .jic file (It may be required to click a box or two to say program, I forget)
#Tell it to start

If you flashed a .sof, then it will start immediately. It will only last until power off.

If you flashed a .jic, then it will require the board powering off/on to load. This will load until you flash the next jic or update via sd card.

Updated by foft over 6 years ago · 3 revisions