Wiki » History » Revision 41
« Previous |
Revision 41/58
(diff)
| Next »
foft, 05/27/2018 07:38 PM
Introduction¶
For now please see the general core manual on the main page.
http://www.64kib.com/
Power requirements¶
USB B 5V input. 500mA is enough but I'd go with 1-2A to give some extra for any connected devices.
Board setup videos¶
I put together some basic videos for the v2 boards:
https://www.youtube.com/playlist?list=PLYGeDt6lv-p5R4DwdcHtmYUbfL6lOcYLb
SD card setup¶
The OS and basic rom are loaded from the flash chip in the new cores, this can still be overridden by the sd card as discussed here:
http://www.64kib.com/redmine/boards/1/topics/22?r=26#message-26
Updating the core¶
Flashing overview
Core location
Flashing using the USB blaster
Flashing using the SD card
Converting flashing files
Svideo/composite on v2¶
On the v2 board svideo and composite are output via the vga connector:
For svideo luma is on the green output and chroma on the blue output.
For composite luma is on the green output.
Board information¶
Cases¶
In theory any mini ITX case should work as long as it has a full size IO panel.
In practice, please check this list of known good cases. If you have success with another one, please add it.
Keyboard mapping¶
The keyboard is mapped to match the standard Atari keyboard layout. It assumes you are using either an ISO or ANSI keyboard. I highly recommend buying stickers from here: https://www.4keyboard.com/commodore/591-2840-commodore-atari-non-transparent-keyboard-stickers.html
For an ISO keyboard:
Updated by foft over 6 years ago · 41 revisions